Rod Holder, 4 Rod

Four rods on the rail. Drilling, jigging, dead-sticking, deep - all set up and ready.

When two anglers are running multiple presentations on the same hole, you need more rail real estate. This 4-rod holder gives you more lineup than a 3-tube unit without losing the reel-through slot that makes drop-and-fish actually work.

Why this one works:

• Reel-through slots on the front of each tube - drop a rigged rod in WITH the reel attached. No spinning the rod, no removing the reel, no fight.
• 1-1/4 inch tube ID fits standard ice rod handles (Frabill, 13 Fishing, St. Croix Avid, Tuned Up Customs, etc.)
• Open top, solid floor - rods cant slip through, snow brushes off the top
• 4 inch tall tubes - hold rods rock-steady against sled bounce on rough ice
• Maker logo cut clean THROUGH the bracket - never wears off
• 4 bolts distribute load better than 3 for the longer bracket - less flex under heavy gear

Mounts in 5 minutes with wing-nut hardware (included):

• 4 stainless steel button-head bolts (M5 thread, 1 inch long)
• 4 stainless fender washers (3/4 inch OD, top - distributes load)
• 4 stainless fender washers (3/4 inch OD, bottom - protects HDPE rail)
• 4 M5 stainless wing nuts

Drill four 13/64 inch through-holes in your sled rail top, drop the bolts down, wing nuts on from underneath, hand-tighten. Works with gloves on. No drill needed once the holes are made. Removable for off-season or to relocate.

Fits these ice fishing sleds:

• Shappell Jet Sled Jr / 1 / 2
• Otter Pro Sled / Magnum / Outfitter / Pro X-Over
• Eskimo Wide 1 / Eskimo Sport
• Clam Outdoors transport sleds
• Frabill Pro Series sleds
• Any sled with a top-mount HDPE rail

Made in USA. Designed, printed, and field-tested in Wisconsin. Every print is QC-checked before it ships.