Rod Holder, 3 Rod

Three rods. One sled. Zero rolling around in the slush.

Stop watching $80 ice rods bounce off the sled and slide into the snow. This 3 rod holder bolts to the top of any standard ice fishing sled rail and keeps your rigged setups vertical, organized, and ready to grab.

Why this one is different:

• Reel-through slots on the front of each tube. Drop a rigged rod in WITH the reel attached. No spinning the rod, no removing the reel, no fight. This is the feature every cheap holder gets wrong.
• 1-1/4 inch tube ID fits standard ice rod handles - Frabill, 13 Fishing, St. Croix Avid, Tuned Up Customs, the rest.
• Open top, solid floor - rods cant slip through, snow brushes off the top.
• 4 inch tall tubes - deep enough to hold rods steady against sled bounce on rough ice.

Mounts in 5 minutes with wing-nut hardware (included):

• 3 stainless steel button-head bolts (M5 thread, 1 inch long)
• 3 stainless fender washers (3/4 inch OD, top - distributes load)
• 3 stainless fender washers (3/4 inch OD, bottom - protects HDPE rail)
• 3 M5 stainless wing nuts

Drill three 13/64 inch through-holes in your sled rail top, drop the bolts down, wing nuts on from underneath, hand-tighten. Works with gloves on. No drill needed once the holes are made. Removable - take it off in summer or swap to a different sled.

Fits these ice fishing sleds:

• Shappell Jet Sled Jr / 1 / 2
• Otter Pro Sled / Magnum
• Otter Outdoors Outfitter / Hideout / Pro X-Over
• Eskimo Wide 1 / Eskimo Sport
• Clam Outdoors transport sleds
• Frabill Pro Series sleds
• Any sled with a top-mount HDPE rail

Made in USA. Designed and printed in-house in Wisconsin on a Sovol SV08 with our custom slicer profile. Wisconsin ice anglers test every print on Lake Menomin before it goes in the shop.